Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Operating the tailgate

Ensure there is minimum space of 1.0M (39 in) above the rear of vehicle before operating the tailgate. Insufficient space may result in damage to the vehicle. Do not operate the tailgate if a cycle rack is fitted to the tailgate. Remove any cycles and/or racks before operating the tailg

 Anti-Lock Control - Traction Control FWD

Component Location NOTE: RHD (right-hand drive) installations shown; LHD (left-hand drive) installations similar. COMPONENT LOCATION - SHEET 1 OF 2 RH (right-hand) front wheel speed sensor RH rear wheel speed sensor LH (left-hand) rear wheel speed sensor LH front wheel speed sensor Integrate

© 2011-2025 Copyright www.rrevoque.org