Range Rover Evoque: Dsc warning lamp
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control / Dsc warning lamp
The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started.
If the lamp flashes while driving, the DSC system is active. If the lamp illuminates continuously while driving, there is a fault with the DSC system. The vehicle can still be driven, but the DSC system will not activate under wheel spin or slide conditions.
Seek qualified assistance as soon as possible.
READ NEXT:
Disabling dsc
Safety may be reduced by
inappropriately disabling DSC. In the
majority of driving situations, and
particularly on-road, it is
recommended that you do not disable
DSC.
In some driving condition
Re-enabling dsc
DSC is re-enabled by one of the following:
- Press and briefly hold the DSC OFF switch.
- Stop and restart the engine.
- Select a new Terrain Response special
program.
Electronic traction control (ETC)
ETC operates in conjunction with Dynamic
Stability Control (DSC) and is designed to
assist when one or more wheels have lost
traction.
If a wheel loses traction, ETC will operate the
brake on tha
SEE MORE:
Wheel Knuckle Rear Bushing
Special Tool(s)
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, Wheel Knuckle Bushing
LR-121
Hydraulic Cylinder 10t
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the
Power Liftgate Switch, Liftgate
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedure.
Liftgate
Removal
CAUTION: The headliner must be lowered as a complete unit to gain access
to the
© 2011-2025 Copyright www.rrevoque.org
