Range Rover Evoque: Sensor blockage
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Blind spot monitoring / Sensor blockage
If one of the sensors is completely obscured the BSM system is automatically disabled, the warning indicator dot is displayed in the exterior mirror and the message BSM sensor blocked appears in the message centre.
Note: Blockage testing is only initiated when vehicle speed is above 32km/h (20mph) and will take at least two minutes of accumulated driving above this speed, to determine that the sensor is blocked.
If the sensors become blocked, then please check that there is nothing obscuring the rear bumper and that it is clear from ice, frost and dirt.
Note: The BSM system is inoperative while a trailer is attached and the trailer socket is used.
READ NEXT:
System fault
If a fault with one of the radar sensors is
detected, an amber warning indicator dot is
displayed in the exterior mirror and the
message BSM not available is displayed in the
message centre.
Note
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
SEE MORE:
Drive Clutches, Planetary Gear Train
DRIVE CLUTCHES
Multiplate Drive or Brake Clutch - Typical
Input shaft
Main pressure supply port
Piston
Cylinder - External plate carrier
Clutch plate assembly
Baffle plate
Diaphragm spring
Output shaft
Bearing
Dynamic pressure equalisation chamber
Piston chamber
Lubrication channel
Th
After towing on four wheels
1. Apply the parking brake. For vehicles with
an automatic gearbox, apply the footbrake
and then select Park position.
2. Switch off the ignition and remove the
Smart Key from the vehicle.
3. Remove the towing attachment and refit
the cover panel to the front bumper.
Use extreme caution when
© 2011-2025 Copyright www.rrevoque.org
