Range Rover Evoque: Trip computer
The computer memory stores data for a
journey or series of journeys until it is reset to
zero.
The displayed information is for guidance only,
as it can be affected by traffic, road and
weather conditions.
Three independent memories are available, A,
B and Auto. A and B memories can be reset
independently, while the Auto trip will reset
after every ignition cycle as the vehicle moves.
Trip computer information is displayed on the
instrument panel.
READ NEXT:
Changing the display
Press the TRIP button on the end of the left
column stalk repeatedly to display the trip data
in the following order:
- Date and odometer.
- Trip distance.
- Average speed
Distance travelled since the last memory reset.
The maximum trip reading is 9 999.9
(kilometres or miles). The computer will
automatically reset to zero if this distance is
exceeded.
This shows the predicted distance, miles or
kilometres, that the vehicle should travel on the
remaining fuel, assuming fuel consumption
stay constant.
SEE MORE:
Draining
WARNING: Observe due care when draining, as the fluid can be very hot.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Make sure that the automatic transmission is in the PARK position
and the handbrake is fully applied.
2. Refer to
Removal
CAUTION: LH illustration shown, RH is similar.
NOTES:
Removal steps in this procedure may contain installation details.
The ignition must be switched off.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Front Bumper Cover (501-19 B
© 2011-2025 Copyright www.rrevoque.org
