Range Rover Evoque: Child seat positioning

children are Crash statistics show that children are safest when properly restrained in a child or infant restraint system that is secured in a rear seating position.

table is Information given within the table is correct at the time of going to press.

However, availability of child restraints may change. Please consult your Dealer/Authorised Repairer for the latest recommendation.

Note: The information contained in the following table may not be applicable to all countries. If you are in any doubt regarding the type and fitment of child seats seek advice from your Dealer/Authorised Repairer.

Note: Ages given are approximate. In case of doubt, the child’s weight not age should be used when considering an appropriate child seat.

Note: The legislation which governs how and where children should be carried when travelling in a vehicle, is subject to change. It is the responsibility of the driver to comply with all regulations in force.

U = Suitable for universal category restraints

U = Suitable for universal category restraints approved for this mass group.

* Always ensure that the passenger airbag has been disabled before using a child restraint in this seating position. See 36, DISABLING THE PASSENGER AIRBAG (not Australia). The seat back needs to be adjusted to the fully upright position.

READ NEXT:

 Recommended child seats

Recommended child seats

 Child restraint check list

Every time a child travels in the vehicle observe the following: - Use appropriate child restraints. - Carefully follow the restraint system manufacturers instructions. - Adjust the harnesses for

 Isofix anchor points (not Australia)

Do not attempt to fit ISOFIX restraints to the centre rear seating position. The anchor bars are not designed to hold an ISOFIX restraint in this position. If the restraint is not correctly a

SEE MORE:

 Seat belts

Do not allow any water, cleaning products, or fabric from cloths to enter the seat belt mechanism. Any substance which enters the mechanism may affect the performance of the seat belt in an impact. Extend the seat belts fully, then use warm water and a non-detergent soap to clean. Allow

 Before programming

When programming a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure. For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other devic

© 2011-2025 Copyright www.rrevoque.org