Range Rover Evoque: Kick-down
Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear changing will resume.
READ NEXT:
Drive selector
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
Drive selector fails to elevate
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
SEE MORE:
Side Panel
Removal
NOTES:
The side panel is manufactured from mild steel. The fender mounting
bracket is serviced on the new panel.
This procedure identifies the method for the replacement of the side panel in
full. There are possible alternative sections of the side
panel that can be performed dependant on
Oil check preparation
Prior to checking the oil level ensure that:
- The vehicle is on level ground.
- The engine oil is cold.
Note: If it is necessary to check the oil level
when the engine is hot, switch off the engine
and let the vehicle stand for 5 minutes to allow
the oil to drain back into the sump. Do not st
© 2011-2025 Copyright www.rrevoque.org
