Range Rover Evoque: Kick-down
Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear changing will resume.
READ NEXT:
Drive selector
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
Drive selector fails to elevate
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
SEE MORE:
Suspension System - General Information
Coil Spring Suspension
Wheel Alignment Specification (All Markets) - Front
NOTE: All figures are with vehicle at 'Showroom' ride height - full
fluids, full tank of fuel, no occupants/luggage, tires
inflated to normal pressures
Wheel Alignment Specification (All Markets) - Rear
NOTE: All figures a
Rocker Panel
Removal
NOTES:
The rocker panel is manufactured from mild steel.
Some of the butt joints must be MIG brazed due to the location of boron
reinforcements.
1. This procedure
identifies the
method for the
replacement of
the rocker
panel in full.
The graphic
and table
identify
possible
alternative
sec
© 2011-2025 Copyright www.rrevoque.org
