Range Rover Evoque: Oil Pump
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.
Removal steps in this procedure may contain installation details.
1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
4. Refer to: Air Cleaner (303-12B Intake Air Distribution and Filtering - GTDi 2.0L Petrol, Removal and Installation).
5. Refer to: Air Conditioning (A/C) Compressor - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).
6. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).
7. CAUTION: Using a suitable tool, hold the oil pump gear when removing the centre bolt.
- Torque: 25 Nm
8.
9. Torque: 8 Nm
10. Torque: 25 Nm
11. Torque: 35 Nm
12. Torque: 4 Nm
13.
14. Torque: 10 Nm
15. NOTE: During installation tighten the bolts simultaneously or crosswise.
Torque:
- Stage 1: 10 Nm
- Stage 2: 20 Nm
Installation
1. NOTE: Make sure that all traces of the old sealant are removed from the mating faces. To install, reverse the removal procedure.
2. NOTES: Install a new gasket.
Note - Apply sealant WSE-M4G323-A6 in a 2-3mm diameter on the engine oil sump as shown. The component must be installed and tightened within 10 minutes of sealant application.
3. NOTE: Note - TAS | Engine | Apply sealant WSE-M4G323-A6 in a 2-3mm diameter on the engine front cover as shown. The component must be installed and tightened within 10 minutes of sealant application.
READ NEXT:
Timing Chain
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Specifications
Timing Cover
Special Tool(s)
303-021
Engine support bracket
JLR-303-1591
Lifting Bracket, Engine - Rear
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustratio
Valve Cover
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
SEE MORE:
Petrol and Petrol-Ethanol Fuel Systems Health and
Safety Precautions
WARNINGS:
Fuel may not give adequate warning before toxic or harmful effects arise.
Exposure to fuel can be harmful and can cause severe health damage or death.
Extreme care must be exercised when handling hot fluids. Always wash off spilled
fluids from affected areas of skin
immediately.
Hig
Keyless locking
Never double lock the vehicle
with
people, children or pets inside. In the
event of an emergency they would be
unable to escape and the emergency
services would be unable to release
them quickly.
The Smart Key may not be
detected if it
is placed within a metal container or if it
is shi
