Range Rover Evoque: Speed Control

Range Rover Evoque. Speed Control

Speed Control Actuator

Removal

1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).

Installation

1. To install, reverse the removal procedure.

Speed Control Deactivator Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. CAUTION: LH illustration shown, RH is similar.

Range Rover Evoque. Speed Control

2.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

Speed Control Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Make the air bag supplemental restraint system (SRS) safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).

4. Torque: 1.3 Nm

Range Rover Evoque. Speed Control

5. CAUTION: Take extra care not to damage the edges of the component.

Torque: 2.1 Nm

Range Rover Evoque. Speed Control

6. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Climate Control System

 Climate Control System - General Information

Climate Control Lubricants, Fluids, Sealers and Adhesives General Specification Capacities Refrigerant oil adding capacities for replacment parts NOTE: Rotate the A/C compressor shaft at least 6 t

 Climate Control

SEE MORE:

 Electric parking brake (EPD)

The parking brake operates on the rear wheels. Therefore, secure parking of the vehicle is dependent on being on a hard and stable surface. Do not rely on the parking brake to operate effectively, if the rear wheels have been immersed in mud or water. Note: If the vehicle is used in severe

 Disabling stop/start

Disabling stop/start To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off. Note: The engine will restart automatically If the switch is pressed to disable the system, while an automatic engine st

© 2011-2025 Copyright www.rrevoque.org