Range Rover Evoque: Stalled adjustment

movement stops unexpectedly If seat movement stops unexpectedly during adjustment check for any obstructions and remove.

Once any obstructions have been removed the seat adjustment mechanism can be reset as follows.

Operate the button again to continue the stalled adjustment. When seat movement resumes hold the button until the end of travel in that direction has been reached. The seat position can now be carried out as normal.

Note: If no obstructions can be seen, but normal adjustment cannot be carried out without stalling, contact your Land Rover Dealer/Approved Repairer.

READ NEXT:

 Sitting in the correct position

The driver and front seat passenger must not ride with the seat fully reclined. Do not adjust the seat while the vehicle is moving. The seat, head restraint, seat belt and airbags, all con

 Memory seats

Front seat positions can be saved to vehicle memory. Once you have adjusted the power operated driver’s seat and the exterior mirrors, the vehicle can memorise the settings for future use. See

 Easy entry/exit

When Easy entry/exit is configured, the driver’s seat will automatically lower when the ignition is switched off and the door release lever is used. Upon returning to the vehicle, when the drive

SEE MORE:

 Transmission Vehicles With: M66 6-Speed Manual Transmission AWD - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

 Voice control operation

Voice control operation 1. Voice button: Press briefly to start a voice session. A pop up will appear on the touch screen. Press and hold to cancel a voice session. Note: Briefly press the Voice button during a voice session, to interrupt audible feedback. Wait for the tone to sound before

© 2011-2025 Copyright www.rrevoque.org