Range Rover Evoque: Throttle Body
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
3. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
4.
5.
6.
7. NOTE: Install a new O-ring seal. Torque: 8 Nm
Installation
1. To install, reverse the removal procedure.
Fuel Injectors
Removal
1. Refer to: Fuel Rail (303-04C Fuel Charging and Controls - GTDi 2.0L Petrol, Removal and Installation).
Installation
1. To install, reverse the removal procedure.
Fuel Charging Wiring Harness
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Intake Manifold (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
4.
5.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Fuel Rail
Special Tool(s)
310-198
Installer, Teflon Seal
310-199
Re-shape Tool, Teflon Seal
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Some variation in the illustrat
Fuel Pump
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel
spillage at all times and always observe fuel
handling precautions. Failure to follow these instructions may result in
pe
Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
Torque Specifications
Turbocharger
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always
SEE MORE:
Front Bumper Mounting
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment jig.
2. The front bumper mounting is replaced in conjunction with:
Front bumper cover
Front bumper
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear height sensor
Headlamp leveling control module
Front right fog lamp
Front left fog lamp
Left side rep
