Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 C-Pillar Upper Trim Panel

Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. 3. 4. 5. Torque: 6 Nm 6. Installation 1. To install, reverse the removal procedure. C-Pillar Lower Trim Panel Removal 1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation). 2. Refer to: Lo

 Overhead Console

Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTION: Take extra care not to damage the edges of the component. 2. 3. NOTE: Do not disassemble further if the component is removed for access only. 4. CAUTION: Take extra care not to damage the wiring harnesses.

© 2011-2025 Copyright www.rrevoque.org