Range Rover Evoque: Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch on automatically
under the following conditions:
- The engine is running.
- The gear selector is out of park (automatic
transmission).
- The parking brake is not applied - market
dependent.

Unless required or prohibited by law,
daytime running lamps can be disabled
or enabled by your Dealer/Authorised
Repairer.
READ NEXT:
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only acti
If Auto lamps is selected and the windscreen
wipers are switched on for 20 seconds or
more, the side lamps, tail lamps and
headlamps will switch on automatically. When
the wipers are switched off,
SEE MORE:
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The rocker panel butt joint in option 2 must be MIG brazed due to the location
of boron reinforcements.
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle m
© 2011-2025 Copyright www.rrevoque.org
