Range Rover Evoque: Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. WARNING: Make sure that a new nut is installed. Torque: 60 Nm
4.
5. WARNING: Make sure that a new bolt is installed. Torque: 200 Nm
6. WARNING: Make sure that a new bolt is installed.
Torque:
Stage 1: 48 Nm
Stage 2: 180
READ NEXT:
Front Stabilizer Bar AWD
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
Only use clean water as a lubricant for the bushing, if required.
Removal steps in this pro
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
Wheel Knuckle
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
sus
SEE MORE:
Xenon lamps
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps should only be carried
out by suitably qualified personnel.
Xenon lamp units operate at a very
hig
Seat belt pre-tensioners
The seat belt pre-tensioners activate in
conjunction with the SRS to provide additional
protection in the event of a severe frontal
impact. They automatically reduce any slack in
a seat belt to reduce forward movement of a
front seat occupant.
The seat belt pre-tensioners
will
activate onl
© 2011-2025 Copyright www.rrevoque.org
