Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
Replacing remote control batteries

With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.

READ NEXT:

 Additional remote controls

A maximum of three controls can be programmed to each vehicle. Contact your Land Rover dealer to purchase additional units and have them programmed to your vehicle.

 Storage compartments

 Cup holders and storage

Cup holders and storage 1. Glovebox. 2. Inside the glovebox is a drop down storage area for the Owner’s Handbook pack. 3. Cubby box. 4. Sliding top to reveal cup holders. Do not drink, or u

SEE MORE:

 Crankshaft Position (CKP) Sensor

Special Tool(s) 303-1390A CKP Sensor Alignment Tool JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Wheel and Tire

 Child restraint check list

Every time a child travels in the vehicle observe the following: - Use appropriate child restraints. - Carefully follow the restraint system manufacturers instructions. - Adjust the harnesses for every child on every trip. - Ensure that all slack is removed from the adult seat belt. - Alway

© 2011-2025 Copyright www.rrevoque.org