Range Rover Evoque: Speed Control

Range Rover Evoque. Speed Control

Speed Control Actuator

Removal

1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).

Installation

1. To install, reverse the removal procedure.

Speed Control Deactivator Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. CAUTION: LH illustration shown, RH is similar.

Range Rover Evoque. Speed Control

2.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

Speed Control Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Make the air bag supplemental restraint system (SRS) safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).

4. Torque: 1.3 Nm

Range Rover Evoque. Speed Control

5. CAUTION: Take extra care not to damage the edges of the component.

Torque: 2.1 Nm

Range Rover Evoque. Speed Control

6. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Climate Control System

 Climate Control System - General Information

Climate Control Lubricants, Fluids, Sealers and Adhesives General Specification Capacities Refrigerant oil adding capacities for replacment parts NOTE: Rotate the A/C compressor shaft at least 6 t

 Climate Control

SEE MORE:

 Rear Side Member Section

Removal NOTES: The rear side member section is manufactured from RP260, with its inner reinforcement manufactured from DP600. The rear side member section is cut from the rear side member service panel, the section also includes the upper and lower side extensions. 1. In this procedure, to make s

 Instrument Panel TD4 2.2L Diesel

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation). 2. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery,

© 2011-2025 Copyright www.rrevoque.org