Range Rover Evoque: Stalled adjustment
If seat
movement stops unexpectedly
during adjustment check for any
obstructions and remove.
Once any obstructions have been removed the
seat adjustment mechanism can be reset as
follows.
Operate the button again to continue the stalled
adjustment. When seat movement resumes
hold the button until the end of travel in that
direction has been reached. The seat position
can now be carried out as normal.
Note: If no obstructions can be seen, but
normal adjustment cannot be carried out
without stalling, contact your Land Rover
Dealer/Approved Repairer.
READ NEXT:
The driver
and front seat passenger
must not ride with the seat fully
reclined.
Do not adjust
the seat while the
vehicle is moving.
The seat, head restraint, seat belt and airbags,
all con
Front seat positions can be saved to vehicle
memory.
Once you have adjusted the power operated
driver’s seat and the exterior mirrors, the
vehicle can memorise the settings for future
use. See
When Easy entry/exit is configured, the driver’s
seat will automatically lower when the ignition
is switched off and the door release lever is
used. Upon returning to the vehicle, when the
drive
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: LH illustration shown, RH is similar.
NOTE: The procedure must be carried out on both
sides.
Torque: 1.9 Nm
Vehicles with manual transmission
2. Refer to: Gearshift Lever Knob (308-06 Manual
T
Disabling stop/start
To switch the system off (preventing automatic
stop/start) press the ECO switch. The LED
indicator will extinguish to confirm that the
system is off.
Note: The engine will restart automatically If
the switch is pressed to disable the system,
while an automatic engine st
© 2011-2025 Copyright www.rrevoque.org
