Range Rover Evoque: Folding and raising the rear seats
Folding and raising the rear seats
The split fold rear seat of 5 door models can be folded completely, or partially at 60/40 split, to accommodate loads and still retain seating for passengers.
To fold part or all of the seat: 1. Fully lower the head restraints.
2. Press either seat backrest release button, then fold the appropriate backrest fully forward.
Raising a folded seat is a reversal of the folding process.
When the seat back is fully raised and locked into position, the release/locking button will pop up.
With the Coupe 3 door models, if a fold is required, the smaller part must be folded first.
The larger part can then be folded.
Raising the Coupe folded seats is a reversal of the folding process. Ensure that the release/locking button relocates into the correct position.
Ensure that when the backrest
is
raised the locking mechanism is fully
engaged. If the backrests are not fully
locked in place, red markers will be
visible around the backrest buttons.
READ NEXT:
Rear seat head restraints
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
Steering column
Never adjust the steering
column
while the vehicle is in motion.
1. Move the lever fully down to unlock the
column. Move the lever fully up to re-lock
the column.
2. Move the steering column u
SEE MORE:
Driver override options
Although Dynamic Stability Control is
automatically engaged when a special program
is selected, it can be turned off if required. See
91, DISABLING DSC.
Hill Descent Control (HDC) will be
automatically engaged for some terrain
response programs. If required it can be
deselected or engaged ind
Suspension Top Mount
Removal
NOTES:
The suspension top mount is manufactured from mild steel and RP220.
The service panel is serviced not fully spot welded.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2.
