Range Rover Evoque: Front Lower Arm

Removal

NOTES:

Some variation in the illustrations may occur, but the essential information is always correct.

Front wheel drive transmission illustrations shown, all wheel wheel drive transmission is similar.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3.

Range Rover Evoque. Rear Suspension

4.

Range Rover Evoque. Rear Suspension

Installation

1. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

2. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

3. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

Support weight of vehicle on a jack at the rear hub.

4. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

5. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

6. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

READ NEXT:

 Rear Lower Arm AWD

Special Tool(s) 205-857 Remover, Halfshaft Removal CAUTION: LH illustration shown, RH is similar. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

 Rear Stabilizer Bar

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure

 Wheel Knuckle

Special Tool(s) 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshaf

SEE MORE:

 Pairing and connecting a bluetooth® media device

For further information on Bluetooth® and device compatibility, see 141, BLUETOOTH® INFORMATION. Using your media device Note: The process of pairing and connecting your media device with the vehicle using the media device, will vary depending on the type of media device. 1. Switch the ign

 Rear Inner Quarter Panel

Removal NOTES: The rear inner quarter panel is manufactured from mild steel. The rear inner quarter panel is unpicked from the inner quarter panel, it is not serviced separately. There are NVH components on this panel, they are not serviced on the new panel. If damaged, new components will be re

© 2011-2025 Copyright www.rrevoque.org