Range Rover Evoque: Front seat heaters
Press the relevant button to operate the
required seat heater at high level. Three
indicators will illuminate.
Press a second time to heat the seat at a
medium level. Two indicators will illuminate.
Press a third time to heat the seat at the lowest
level. One indicator will illuminate.
Press a fourth time to switch off.
Note: Seat heaters consume a great amount of
battery power. They will operate only when the
engine is running.
READ NEXT:
- Press briefly to activate timed
recirculation. The button indicator
illuminates when recirculation is on.
- Press and hold the button to activate
latched recirculation. The button indicator
wil
- Press the AUTO button briefly to activate
timed recirculation. The AUTO LED will
illuminate. The system automatically
selects fresh and recirculated air
dependent on pollution and cabin
humidit
The climate control system removes moisture
from the air and deposits the excess water
beneath the vehicle. Puddles may form but this
is normal and is no cause for concern.
SEE MORE:
Windshield Wiper Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Plenum Chamber (412-01 Climate Control, Removal and
Installation).
2. NOTE: LHD illustration shown, RHD is similar.
Torque: 8 Nm
Installation
1. To install, reverse the removal proced
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear height sensor
Headlamp leveling control module
Front right fog lamp
Front left fog lamp
Left side rep
© 2011-2025 Copyright www.rrevoque.org
