Range Rover Evoque: How it works

Viewing angles for driver and front seat passenger are such that neither can view the full display that the other is viewing. However, there is an optimum viewing angle of 30 degrees where no cross over of images can be perceived. From this point, the closer to screen centre or screen side edges that the viewer moves to, the more likely cross over of images is. During normal use of dual view, image cross over is unlikely.

Rear seat passengers may be able to see both

Rear seat passengers may be able to see both views when dual view is active.

READ NEXT:

 Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view. To select dual view, press the dual view hard key on the fascia s

 Dual view control menu

Dual view control menu 1. Select to cancel dual view and revert to the menu for the current video source (TV, DVD). Note: The preview screen will be deactivated if the vehicle is moving. 2. Se

 Dual view tv operation

If you would like to change the TV programme while the vehicle is moving, there are two methods available; 1. Press the dual view hardkey to display the control menu. Select an alternative channe

SEE MORE:

 Locks, Latches and Entry Systems

Principle of Operation For a detailed description of the locks, latches and entry systems and operation, refer to the relevant Description and Operation section of the workshop manual REFER to: Handles, Locks, Latches and Entry Systems (501-14 Handles, Locks, Latches and Entry Systems, Description

 Steering Wheel Module

Steering Angle Sensor Module (SASM)  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle  NOTES: I

© 2011-2025 Copyright www.rrevoque.org