Range Rover Evoque: Fuel Pump
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in personal injury.
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
3. Refer to: Air Cleaner Intake Pipe (303-12B Intake Air Distribution and Filtering - GTDi 2.0L Petrol, Removal and Installation).
4.
5.
6. CAUTION: Discard the fuel pipe.
7.
8.
9.
10.
11. CAUTION: Discard the bolts.
Installation
1. CAUTIONS:
Make sure that the mating faces are clean and free of foreign material.
Apply sealant WSE-M4G323-A6 in a 5mm diameter on the gasket as illustrated. Install the gasket immediately after applying the sealant without smearing the sealant.
2. CAUTION: Make sure that the mating faces are clean and free of foreign material.
Torque: 20 Nm
3. CAUTIONS:
Install all the bolts finger tight before final tightening.
Make sure that new bolts are installed.
NOTE: Lubricate the O-ring seal with clean engine oil.
Torque:
- Stage 1: 5 Nm
- Stage 2: 55
READ NEXT:
Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
Torque Specifications
Turbocharger
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always
Accessory Drive - GTDi 2.0L Petrol
Torque Specifications
Accessory Drive Belt
Removal
NOTE: Some illustrations may show the engine removed for clarity.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery
Starting System - GTDi 2.0L Petrol
Starting System - Component
Location
COMPONENT LOCATION
Solenoid
12V supply from battery
Solenoid power supply from Battery Junction Box (BJB)
Starter motor
Pinion gear
Starting System - Overv
SEE MORE:
Headliner
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield Glass (501-11 Glass, Frames and Mechanisms,
Removal and Installation).
3-door
2. NOTE: The procedure
Mislock
When locking the vehicle with the Smart Key, if
one or more of the doors, the bonnet or the
tailgate is not fully closed, or the ignition is ON,
the vehicle will NOT lock and there will be an
audible mislock error warning. The hazard
warning lamps will NOT flash and the door
mirrors (if enable
