Range Rover Evoque: Before programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programming.
If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.
READ NEXT:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
SEE MORE:
Seat belt pre-tensioners
The seat belt pre-tensioners activate in
conjunction with the SRS to provide additional
protection in the event of a severe frontal
impact. They automatically reduce any slack in
a seat belt to reduce forward movement of a
front seat occupant.
The seat belt pre-tensioners
will
activate onl
Cooling Fan
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Cooling System
© 2011-2025 Copyright www.rrevoque.org
