Range Rover Evoque: Kick-down
Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear changing will resume.
READ NEXT:
Drive selector
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
Drive selector fails to elevate
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
SEE MORE:
Event data recording
Event data recorders are capable of collecting
and storing short sequences of data during a
crash or near-crash event. The recorded
information may assist in the investigation of
such an event. The EDR may record
information about vehicle dynamics and safety
systems, potentially including such
Rocker Panel Inner Reinforcement
Removal
NOTES:
The rocker panel inner reinforcement is manufactured from boron steel.
The rocker panel inner reinforcement is unpicked from the side panel
reinforcement 'ring-frame', it is not serviced separately.
In this procedure the b-pillar reinforcement will be fitted in combination with
th
© 2011-2025 Copyright www.rrevoque.org
