Range Rover Evoque: Re-enabling dsc
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control / Re-enabling dsc
DSC is re-enabled by one of the following: - Press and briefly hold the DSC OFF switch.
- Stop and restart the engine.
- Select a new Terrain Response special program.
READ NEXT:
Electronic traction control (ETC)
ETC operates in conjunction with Dynamic
Stability Control (DSC) and is designed to
assist when one or more wheels have lost
traction.
If a wheel loses traction, ETC will operate the
brake on tha
Adaptive dynamics
The adaptive dynamics continuously monitor
road and driver inputs. It detects rough road
and off road conditions, optimises the vehicle
suspension settings to suit each surface type
and adjusts co
SEE MORE:
Rear Wheelhouse Outer
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
Engine Wiring Harness TD4 2.2L Diesel, Vehicles With:
M66 6-Speed Manual Transmission AWD/M66 6-Speed Manual
Transmission FWD
Removal
CAUTIONS:
Make sure that the wiring harness is not twisted or damaged on removal. Failure
to follow this instruction may result
in damage to the vehicle.
Take extra care not to damage the wiring harness clips.
NOTES:
Some variation in the illustrations may occur, but the essential informa
© 2011-2025 Copyright www.rrevoque.org
