Range Rover Evoque: Rear Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Prior to carrying out the step by step procedure below, Steps 2 and 3 must be followed for knowledge on how to correctly install and care for the seat cover.
2.
3.
4. If required, follow the steps below to carry out the removal and installation procedure.
5. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
6.
7. NOTE: Make sure that new hog rings are installed.
Installation
1. NOTES:
If a replacement rear seat backrest cover is to be installed, cut out holes for the head restraint guide tubes and center safety belt trim panel. Use the existing rear seat backrest cover as a template. This also applies to the backrest squab foam.
Use hog ring pliers to close the hog rings. Do not use any other tool. The hog rings must be closed to overlap as illustrated.
Make sure that new hog rings are installed.
2. NOTE: Make sure that the hogrings are installed in the sequence shown.
3. NOTE: Make sure that the hogrings are installed in the sequence shown.
4. To install, reverse the removal procedure.
READ NEXT:
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
Rear Seat Backrest Cover 3-Door
Removal
NOTES:
This procedure covers the removal and installation of both rear seat
backrests and the LH rear seat backrest cover.
The RH rear seat backrest cover is similar. All notes and cautions
Front Seat Track
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
SEE MORE:
Transfer Case Fluid
Level Check
CAUTION: The fluid filler plug is not a fluid level plug.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Fron
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mounted in the engine compartment. The engine weight is kept
to a minimum by using aluminum for
the cyli
