Range Rover Evoque: Selecting valet mode

Valet mode allows the vehicle to be driven, e.g., by a parking attendant, but leaves the tailgate locked and restricts use of the touch screen.

This prevents access to telephone numbers, navigation addresses and audio system settings.

From the Home menu, select Valet: Enter a four digit Personal identification Number (PIN) (personally chosen). On completion, touch the OK soft key.

If you wish to cancel the PIN, select Delete.

After entering the PIN, you will be prompted to enter the PIN again. Enter the same PIN and touch OK to confirm.

A pop-up screen is displayed, confirming your vehicle is now in Valet mode.

READ NEXT:

 Interior protection

The interior protection feature of the full alarm system may be temporarily disabled via Alarm sensors in the Vehicle Settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU. Note: If the in

 Battery-backed sounder

In certain markets, a battery backed sounder is fitted. This device will sound if it or the vehicle battery is disconnected while the security system is armed.

 Tilt sensor

The tilt sensor detects any change to the vehicle’s angle to the ground. When the alarm is armed and the vehicle is double locked, any change in the vehicle’s angle will activate the tilt alar

SEE MORE:

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may help. DSC should be switched on again as soon as the difficulty is overcome. If the sand to be cros

 Engine Timing

Special Tool(s) 303-1565 Locking Tool, Camshaft 308-511 Installer, Transmission Output Shaft Seal JLR-303-1594 Locking Tool, Driveplate JLR-303-748 Locking Tool, Crankshaft Activation 1. 2. Install the special tool. Special Tool(s): JLR-303-748 3. Rotate the engine clockwise until the crankshaft

© 2011-2025 Copyright www.rrevoque.org