Range Rover Evoque: Set or increase cruise speed
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle speed
exceeding the speed limit.
Note: Cruise control can be engaged only at speeds in excess of 30km/h (18mph).
Accelerate until the desired speed is reached, then press control (1). This sets the vehicle speed into the system's memory. Cruise control will now maintain that speed.
The cruise control warning
lamp
will illuminate to confirm cruise
control is operational.
Speed can still be increased using the accelerator pedal. As soon as the accelerator pedal is released, the vehicle speed will return to the set cruising speed.
Note: If the accelerator pedal is pressed for more than 60 seconds, cruise control will be cancelled.
To increase the set cruise speed, press and hold control (1). Release the switch when the desired speed is reached, the new speed will be set and maintained.
The speed can be increased in steps of 2km/h (1mph), by briefly pressing control (1).
Speed can also be increased using the accelerator. When the desired speed is reached press control (1) to set and maintain the new speed.
Note: The set speed can be erased only by switching off the ignition.
READ NEXT:
Decreasing cruise speed
To reduce cruising speed, press and hold
control (4). Release the switch when the
desired speed is reached, the new speed will be
set and maintained.
The set speed can be decreased in steps of
2k
Suspending and resuming cruise control
Suspend cruise control with a single press of
control (3).
To resume cruise control at the previous set
speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park
SEE MORE:
Front Seat Backrest Cover Vehicles With: Sports Seats
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on h
Safety in the garage
If the vehicle has been
driven
recently, do not touch exhaust and
cooling system components until the
engine has cooled.
Never leave the engine running in an
unventilated area - exhaust gases are
poisonous and extremely dangerous.
Never work or allow any person to
place any part of their
