Range Rover Evoque: To erase all programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / To erase all programming
For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off).
2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.
All memories in HomeLink have now been cleared.
Note: Do not perform this procedure when programming the additional garage door opener buttons.
READ NEXT:
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
Instrument panel
Instrument panel
1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge
Serious engine damage can
occur if
the vehicle is driven while the
engin
SEE MORE:
Fender Apron Panel Reinforcement
Removal
NOTE: The fender apron panel reinforcement is manufactured from mild
steel.
1.
2. For additional information relating to this repair procedure please see
the
following:
For additional information, refer to: Health and Safety Precautions (100-00
General Information, Description and Operat
Fuel filler flap
Take note of all warnings
and
instructions given on the label affixed
to the inside of the filler flap.
The fuel filler flap is located on the right-hand
side of the vehicle, at the rear.
1. If a locking fuel filler flap is fitted, ensure
that the vehicle alarm system is disarmed.
Note: Th
© 2011-2025 Copyright www.rrevoque.org
