Range Rover Evoque: Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.

Automatic transmission - select neutral (N) and then press the engine START/STOP button.

When the engine re-starts, select transmission position D.

Manual transmission - depress the clutch and then press the engine START/STOP button.

When the engine re-starts, select an appropriate forward gear.

READ NEXT:

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t

 Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on. When the engine has been stopped by the stop/start syst

 Conditions preventing automatic engine stop

The engine will not automatically stop if:<> - the external temperature is below approximately 0°C (32°F) - the external temperature is above approximately40°C (104°F) - engine has not re

SEE MORE:

 Rear Side Member Closing Panel

Removal NOTES: The rear side member lower side extension is manufactured from DP600 with a mild steel mounting bracket. The panel is serviced less its weld studs. 1. The rear side member closing panel is replaced 2. For additional information relating to this repair procedure please see the foll

 Front Seat Cushion Cover Vehicles With: Sports Seats

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Prior to carrying out the step by step procedure below, Steps 2 and 3 must be followed for knowledge on how to correctly install and care for the seat cover. 2. 3. 4. If required, follow the steps below

© 2011-2025 Copyright www.rrevoque.org