Range Rover Evoque: Selecting valet mode

Valet mode allows the vehicle to be driven, e.g., by a parking attendant, but leaves the tailgate locked and restricts use of the touch screen.

This prevents access to telephone numbers, navigation addresses and audio system settings.

From the Home menu, select Valet: Enter a four digit Personal identification Number (PIN) (personally chosen). On completion, touch the OK soft key.

If you wish to cancel the PIN, select Delete.

After entering the PIN, you will be prompted to enter the PIN again. Enter the same PIN and touch OK to confirm.

A pop-up screen is displayed, confirming your vehicle is now in Valet mode.

READ NEXT:

 Interior protection

The interior protection feature of the full alarm system may be temporarily disabled via Alarm sensors in the Vehicle Settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU. Note: If the in

 Battery-backed sounder

In certain markets, a battery backed sounder is fitted. This device will sound if it or the vehicle battery is disconnected while the security system is armed.

 Tilt sensor

The tilt sensor detects any change to the vehicle’s angle to the ground. When the alarm is armed and the vehicle is double locked, any change in the vehicle’s angle will activate the tilt alar

SEE MORE:

 Front Door Window Regulator and Motor

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) before commencing any repair or ad

 Front Inner Parking Aid Sensor

Removal CAUTION: LH illustration shown, RH is similar. NOTES: Removal steps in this procedure may contain installation details. The ignition must be switched off. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Bumper Cover (501-19 B

© 2011-2025 Copyright www.rrevoque.org