Range Rover Evoque: Grass-gravel-snow

This program should be used

This program should be used where a firm surface is covered with loose or slippery material.

Note: For deep snow it is recommended that the Sand program is selected.

Note: If the vehicle is unable to gain traction in deep snow, switching DSC off may help. DSC should be switched on again, as soon as the difficulty is overcome.

READ NEXT:

 Mud-ruts

This program should be used for crossing terrain that is muddy, rutted, soft or uneven. HDC is automatically selected with this program.

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may h

 Wading

The maximum advisable wading depth is 500mm (19.7in). If the vehicle remains stationary in water above the door sill level, severe electrical damage may occur. Do not switch off the engine when

SEE MORE:

  Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission FWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 307-594 Installer, Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - FWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. CAUTIONS: Make sure that

  Manual Transmission FWD

Component Location COMPONENT LOCATION Manual transmission Selector lever assembly Overview OVERVIEW The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford in Cologne, Germany. The transmission is a highly compact 4 shaft design, incorporating the front final drive gear.

© 2011-2026 Copyright www.rrevoque.org - 0.0042