Range Rover Evoque: Disabling the passenger airbag (not Australia)
Crash test data and
statistics show
that the safest place for a child to be
restrained is in a child seat correctly
fitted to the vehicle's rear seat.
Do not use a child restraint on a seat
protected by an operational airbag in
front of it. Doing so presents a high
risk of death or serious injury to the
child in the event of an accident.
Do not fit a child restraint to the front
passenger seat if the SRS warning
light illuminates continuously with the
ignition on.
Note: The passenger airbag must be disabled when a rearward facing child restraint is fitted to the front passenger seat.
Airbag disable/enable is achieved via the steering wheel settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU
As soon as the child seat is
removed
from the front passenger seat, the
airbag must be turned on. Failure to
do so will put any front seat
passengers at greater risk of death or
serious injury in the event of an
accident.
When checking the operational
status
of the front passenger airbag, ensure
that the ignition is switched on.
READ NEXT:
Front airbags
The front passenger and driver airbags are able
to deploy in two stages, depending on the
severity of the frontal impact. In a severe
impact, the airbags inflate fully to stage two
giving maximum
Side airbags
These are designed to protect the thorax region
of the torso and will deploy only in the event of
a side impact and then, only on the side of the
impact.
Curtain airbags
The curtain airbags are deployed in side impact
and rollover events, providing greater
protection from serious head injuries. They
deflate at a slower rate than the front or side
airbags.
SEE MORE:
A-Pillar Outer Panel
Removal
NOTES:
The A-pillar outer panel is manufactured from mild steel. The fender
mounting bracket is serviced on the new panel.
The upper and lower butt joint must be MIG brazed due to the location of a boron
reinforcement.
A new anti tamper VIN indentification decal will be required when rep
A-Pillar Reinforcement
Removal
NOTES:
The A- Pillar reinforcement is manufactured from DP600, it is serviced
with its upper and lower door hinge mounting
brackets.
The A-Pillar reinforcement is unpicked from the side panel reinforcement
'ring-frame', it is not serviced separately.
If the A-pillar reinforcement is dama
