Range Rover Evoque: Powered tailgate opening height
The maximum opening height can be set as required. This is useful in parking areas with low ceiling heights or just for ease of use.
1. Open the tailgate to the position which you want to set as the maximum height. Press any tailgate control to stop movement at the required position. Final position can be achieved manually if required.
2. Ensure that the tailgate is stationary for at least three seconds.
3. Press and hold the tailgate close switch for ten seconds to set the maximum opening height.
4. Close the tailgate, then open again to check that it opens to the programmed height.
Note: If, after performing part 3 of the process the tailgate closes automatically, the required height has not been set. Repeat the process ensuring that all steps are adhered to.
To reset the maximum opening height, repeat the process, but when the tailgate reaches its current programmed height, manually move it to the fully open position before pressing and holding the button.
READ NEXT:
Programmed position loss
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close
Changing the smart key batttery
When the battery needs renewing, there will be
a significant decrease in the effective range and
the message SMART KEY BATTERY LOW will
be displayed in the message centre.
To renew the battery:
SEE MORE:
Xenon lamps
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps should only be carried
out by suitably qualified personnel.
Xenon lamp units operate at a very
hig
Headlamps
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove the four grille fixings.
4. Remove the two retaining bolts.
5. At the rear of the headlamp unit, p
