Range Rover Evoque manuals

Range Rover Evoque: Tyre repair kit

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Tyre repair kit / Tyre repair kit

regarding your If you are in any doubt regarding your ability to carry out the instructions, contact your Dealer/Approved Repairer before attempting the repair.

Your vehicle may not be equipped with a spare tyre. If this is the case, your vehicle will be fitted with a Land Rover tyre repair kit which can be used to repair one tyre. It is essential that you read the following guide before attempting to repair a tyre.

The tyre repair kit seals most punctures with a maximum diameter of 6 mm (1/4 inch).

The tyre repair kit is located in the rear underfloor storage compartment.

Note: The sealant used in the tyre repair kit has a shelf life, and the expiry date is shown on the top of the bottle. Ensure that the bottle is replaced before the expiry date.

READ NEXT:

 Safety information

Some tyre damage may only be partially sealed, or may not seal at all, depending on the amount and type of damage. Any loss of tyre pressure can seriously affect vehicle safety. Do not use the t

 Land rover tyre repair kit

Land rover tyre repair kit 1. Maximum speed label. 80 km/h (50 mph). 2. Tyre inflation hose. 3. Inflation hose protective cap. 4. Inflation hose connector. 5. Compressor power cable. 6. Power

 Using the repair kit

Avoid skin contact with the sealant which contains natural rubber latex. Do not unscrew the sealant bottle from the receiver until it is empty, as sealant will leak out. If the tyre inflation

SEE MORE:

  Bolt and Nut Identification

An ISO metric bolt or screw made of steel and larger than 6 mm in diameter can be identified by either of the symbols ISO M or M embossed or indented on top of the bolt head. In addition to marks identifying the manufacturer, the top of the bolt head is also marked with symbols indicating the st

  Pipes and Hoses

When removing or installing flexible hydraulic pipes and hoses, make sure that the following procedures are observed to make sure component serviceability: Prior to removal, clean area around hose or pipe end which is to be disconnected. Obtain appropriate blanking plugs or caps before disconn

© 2011-2026 Copyright www.rrevoque.org - 0.0048