Range Rover Evoque: Catalyst Monitor Sensor
Special Tool(s)
310-121
Wrench, H02S
Removal
WARNING: Observe due care when working near a hot exhaust system.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
4.
5.
6. Torque:
- M6 10 Nm
- M10 45 Nm
7.
8. CAUTIONS:
Make sure that the mating faces are clean and free of corrosion and foreign material.
Note the fitted position of the component prior to removal.
Special Tool(s): 310-121
Torque: 48 Nm
Installation
1. CAUTIONS:
If accidentally dropped or knocked install a new sensor.
Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
Make sure the anti-seize compound does not contact the heated oxygen sensor (HO2S) tip.
NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
To install, reverse the removal procedure.
Front Knock Sensor (KS)
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Intake Manifold (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
3. CAUTION: Note the fitted position of the component prior to removal.
NOTE: Make sure that the component is installed to the noted removal position.
Torque: 20 Nm
Installation
1. To install, reverse the removal procedure.
Rear Knock Sensor (KS)
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Intake Manifold (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
3. CAUTION: Note the fitted position of the component prior to removal.
NOTE: Make sure that the component is installed to the noted removal position. Torque: 20 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Electronic Engine Controls
Principles of Operation
For a detailed description of the 2.0L GTDi petrol electronic engine
controls, refer to the relevant Description and Operation
section in the workshop manual. REFER to: (303-1
SEE MORE:
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; F = RF transmission; N = Medium speed CAN (controller
area network) bus; O = LIN (local
interconnect network) bus.
Instrument cluster
CJB (central junction box)
Radio frequency (RF) receiver
RFA (remote function actuator) / KVM (keyless vehicle module)
Re
Component Description
DOOR LATCHES
Door interior lock/unlock button
Door interior release handle
Door lock exterior release cable
Emergency mechanical door lock (front LH door only)
Exterior door handle lock cover
Exterior door handle
Door latch
Electrical connection to door control module
Door lock interior r
