Range Rover Evoque: Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching specification. Using
an incorrect fuse, may result in damage
to the vehicle's electrical system and
can result in a fire.
If the replacement fuse blows after
installation, the system should be
checked by your Dealer/Authorised
Repairer.
Note: Land Rover recommend that relays should only be replaced by qualified persons.
The fuse removal tweezers are located in the passenger compartment fusebox. Press the tweezers onto the head of a fuse and pull to remove. A break in the wire inside the fuse indicates that the fuse has blown and must be replaced.
There are some spare replacement fuses in the passenger compartment fusebox. See the fuse box label for details.
READ NEXT:
SEE MORE:
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear height sensor
Headlamp leveling control module
Front right fog lamp
Front left fog lamp
Left side rep
Component Description
LEFT STEERING COLUMN MULTIFUNCTION SWITCH
Off position
Side lamps position
Headlamps position
AUTO - Automatic headlamps position (if fitted)
Front fog lamps switch
Rear fog lamps switch
High beam
Right turn signal indicator
Left turn signal indicator
High beam position
High beam flash
