Range Rover Evoque: Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching specification. Using
an incorrect fuse, may result in damage
to the vehicle's electrical system and
can result in a fire.
If the replacement fuse blows after
installation, the system should be
checked by your Dealer/Authorised
Repairer.
Note: Land Rover recommend that relays should only be replaced by qualified persons.
The fuse removal tweezers are located in the passenger compartment fusebox. Press the tweezers onto the head of a fuse and pull to remove. A break in the wire inside the fuse indicates that the fuse has blown and must be replaced.
There are some spare replacement fuses in the passenger compartment fusebox. See the fuse box label for details.
READ NEXT:
SEE MORE:
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
Hdc operation
With HDC engaged, standard descent speed
will not exceed 20km/h (12.4mph).
While the green warning lamp is continuously
illuminated, HDC target speed can be modified
using the cruise control steering wheel
switches, as follows:
- To increase speed, press and hold switch
(2) until the green po
