Range Rover Evoque: Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching specification. Using
an incorrect fuse, may result in damage
to the vehicle's electrical system and
can result in a fire.
If the replacement fuse blows after
installation, the system should be
checked by your Dealer/Authorised
Repairer.
Note: Land Rover recommend that relays should only be replaced by qualified persons.
The fuse removal tweezers are located in the passenger compartment fusebox. Press the tweezers onto the head of a fuse and pull to remove. A break in the wire inside the fuse indicates that the fuse has blown and must be replaced.
There are some spare replacement fuses in the passenger compartment fusebox. See the fuse box label for details.
READ NEXT:
SEE MORE:
Active On-Demand Coupling Vehicles With:
M66 6-Speed Manual Transmission AWD
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise the vehicle on a lift.
2. Remove the exhaust system.
Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L
Diesel, Removal and Installation).
3. CAUTION: Make sure that the driveshaft is
supported with suitable retai
Differential Case Vehicles With: M66 6-Speed
Manual Transmission AWD
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the LH rear wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and
Installation).
3. Refer
