Range Rover Evoque: Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching specification. Using
an incorrect fuse, may result in damage
to the vehicle's electrical system and
can result in a fire.
If the replacement fuse blows after
installation, the system should be
checked by your Dealer/Authorised
Repairer.
Note: Land Rover recommend that relays should only be replaced by qualified persons.
The fuse removal tweezers are located in the passenger compartment fusebox. Press the tweezers onto the head of a fuse and pull to remove. A break in the wire inside the fuse indicates that the fuse has blown and must be replaced.
There are some spare replacement fuses in the passenger compartment fusebox. See the fuse box label for details.
READ NEXT:
SEE MORE:
Transfer Case Fluid
Level Check
CAUTION: The fluid filler plug is not a fluid level plug.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Fron
Power Transfer
Unit TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front
Drive Halfshafts, Removal and Installation).
3. R
