Range Rover Evoque: Switching off the engine with the vehicle moving
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation arise, then the following procedure applies.
- Press and hold the engine START/STOP button for 2 seconds, or; - Press the engine START/STOP button twice within 2 seconds.
In either case, the warning Engine Stop Button Pressed will be displayed in the message centre.
READ NEXT:
Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
SEE MORE:
Transmission Control Module (TCM), Gear Shift Module (GSM)
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
Driving Modes
A number of different driving modes are available. Some can be selected by
the driver and some are automatically initiated
by the TCM to adapt to different driving conditions.
Normal
Sports
Manual 'CommandShift'
Cooling
Hill Descent Control (HDC)
Cruise
Limp home
Coast
Fast off recognitio
© 2011-2026 Copyright www.rrevoque.org - 0.0038
