Range Rover Evoque: Evaporator Temperature Sensor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
3.
4.
5.
6.
Installation
1. To install, reverse the removal procedure.
Heater Core TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03A Engine Cooling - TD4 2.2L Diesel, General Procedures).
3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).
4. CAUTION: Be prepared to collect escaping coolant.
5.
6. CAUTION: Be prepared to collect escaping coolant.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Condenser TD4 2.2L Diesel
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur
Heater Core and Evaporator Core Housing
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operati
Defrost Vent/Register Blend Door Actuator LHD AWD/LHD
FWD
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
SEE MORE:
Glass, Frames and Mechanisms - Component Location, System
Operation and Component Description
Component Location
COMPONENT LOCATION - DOOR MECHANISMS
Passenger door glass motor
Passenger door module
Rear door glass motor
Rear door module
Rear fuse box
Rear door glass motor
Rear door module
Driver door glass motor
Driver door module
CJB (central junction box)
COMPONENT LOCATION -
Front/Rear Door Window Glass
Front Door Window Glass
Special Tool(s)
501-114
Release Lever, Door Glass
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1 Nm
2. Special Tool(s): 501-114
3.
Installation
1. NOTE: An audible click is heard when the clips are fully
latched.
To install, re
