Range Rover Evoque: Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching specification. Using
an incorrect fuse, may result in damage
to the vehicle's electrical system and
can result in a fire.
If the replacement fuse blows after
installation, the system should be
checked by your Dealer/Authorised
Repairer.
Note: Land Rover recommend that relays should only be replaced by qualified persons.
The fuse removal tweezers are located in the passenger compartment fusebox. Press the tweezers onto the head of a fuse and pull to remove. A break in the wire inside the fuse indicates that the fuse has blown and must be replaced.
There are some spare replacement fuses in the passenger compartment fusebox. See the fuse box label for details.
READ NEXT:
SEE MORE:
Front Side Member Section
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member section is cut from the front side member and is
manufactured from RP260.
This procedure is written for the LH front side member section replacement, the
LH and RH front side member sections differ i
Fender Apron Panel Reinforcement
Removal
NOTE: The fender apron panel reinforcement is manufactured from mild
steel.
1.
2. For additional information relating to this repair procedure please see
the
following:
For additional information, refer to: Health and Safety Precautions (100-00
General Information, Description and Operat
