Range Rover Evoque: Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
Special Tool(s)
JLR-204-804
Lever, Wheel Knuckle
General Equipment
- Transmission jack
- Wooden Block
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
LH illustration shown, RH is similar.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
4.
5. WARNING: Make sure that a new nut is installed.
Torque:
Bolts 10 Nm
nut 60 Nm
6. Torque: 110 Nm
7. Torque: 270 Nm
8.
- General Equipment: Transmission jack
- General Equipment: Wooden Block
9. Torque: 175 Nm
10. CAUTION: Note the fitted position of the component prior to removal.
11. Install the Special Tool(s): JLR-204-804
12.
13. CAUTION: Take extra care not to damage the wiring harnesses.
14. Torque: 32 Nm
15. Torque: 32 Nm
16. NOTES:
Do not disassemble further if the component is removed for access only.
Only if fitted.
Torque: 10 Nm
Installation
1. NOTE: Make sure that the component is installed to the noted removal position. To install, reverse the removal procedure.
Rear Suspension
Principles of Operation
For a detailed description of the Suspension System and operation, refer to the relevant Diagnosis and Testing section of the workshop manual.
REFER to: Suspension System (204-00 Suspension System - General Information, Diagnosis and Testing).
READ NEXT:
Spring Vehicles Without: Dynamic Suspension
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's i
Rear Lower Arm FWD
Removal
NOTES:
LH illustration shown, RH is similar.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with
Rear Suspension FWD
Component Location
Stabilizer link
RH (right-hand) spring and damper assembly
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Stub axle and locknut
Hub
Longitudinal li
SEE MORE:
Dynamic stability control (amber)
Dynamic stability control (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp flashes while driving, the
DSC system is active. If the lamp illuminates
continuously while driving, there is a fault with
the DSC system. The vehi
Heating and ventilation controls
Controls
1. Temperature controls. For individual
driver/passenger settings.
2. Maximum defrost program.
3. Air distribution.
Note: More than one setting may be
selected at a time to achieve the desired
distribution.
4. AUTO mode. For fully automatic operation.
5. Heated windscreen.
6. He
