Range Rover Evoque: Automatic switch off
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Cruise control / Automatic switch off
Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected on vehicles with automatic transmission.
- Dynamic Stability Control is operating.
- The difference between the actual and set speed is too great.
- The vehicle reaches a speed of 170km/h (105.6mph).
- The accelerator pedal is used to accelerate beyond the set speed for too long a period.
Cruise control will switch off and clear the memory when: - The ignition system is switched off.
- A fault occurs. The cruise control system will switch off and cannot be used until the fault is cleared.
READ NEXT:
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
Dynamic stability control (DSC)
DSC is automatically enabled each time the
engine is started, and is automatically enabled
by some of the Terrain response special
programs.
The vehicle is not designed
for
cornering at the sa
SEE MORE:
Glass Roof Panel Blind
Removal
CAUTION: When removing and installing the glass roof panel blind, extreme
cleanliness must be observed at all
times.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. NOTE: The procedure must be carried out on both sides.
Refer to: A-Pillar Trim Panel
Lifting
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
transmission in order that the shaft(s) can be rotated when the vehicle is
raised to the desired height.
© 2011-2026 Copyright www.rrevoque.org
