Range Rover Evoque: B-Pillar Lower Trim Panel, D-Pillar Trim Panel

B-Pillar Lower Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1.

Range Rover Evoque. Interior Trim and Ornamentation

2.

Range Rover Evoque. Interior Trim and Ornamentation

3.

Range Rover Evoque. Interior Trim and Ornamentation

4. CAUTION: Discard the bolt.

Torque: 45 Nm

Range Rover Evoque. Interior Trim and Ornamentation

5.

Range Rover Evoque. Interior Trim and Ornamentation

6.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. WARNING: Make sure that a new bolt is installed.

CAUTION: Make sure the safety belt is secure and correctly installed.

NOTE: Make sure the safety belt is operating correctly.

To install, reverse the removal procedure.

D-Pillar Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

1.

Range Rover Evoque. Interior Trim and Ornamentation

2. NOTE: LH side only.

Range Rover Evoque. Interior Trim and Ornamentation

3.

Range Rover Evoque. Interior Trim and Ornamentation

5-door

4.

Range Rover Evoque. Interior Trim and Ornamentation

3-door

5.

Range Rover Evoque. Interior Trim and Ornamentation

All vehicles

6. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

7.

Range Rover Evoque. Interior Trim and Ornamentation

8.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Front Door Trim Panel

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Torque: 6 Nm 2. Torque: 6 Nm 3. Torque: 0.9 Nm 4. Torque: 1.3 Nm 5-door 5. 3-door 6. All vehicles

 Rear Door Trim Panel

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Torque: 1.3 Nm 2. Torque: 6 Nm 3. Torque: 6 Nm 4. 5. 6. 7. NOTE: Do not disassemble further if the component is

 Headliner

Removal NOTES: Removal steps in this procedure may contain installation details. Vehicles with glass roof panel shown, vehicles without glass roof panel similar. All vehicles 1. Refer to: Windshield

SEE MORE:

 Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation). 3.

 Trailer electrical connection

Connect only approved electrical circuits, which are in good condition, to the trailer socket. The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer. When a trailer electrica

© 2011-2026 Copyright www.rrevoque.org