Range Rover Evoque manuals

Range Rover Evoque: Bulb specification chart

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Technical specifications / Bulb specification chart

a bulb, Before attempting to replace a bulb, ensure that both the affected lamp and the vehicle's ignition, are turned off. If the circuit remains live, a short circuit can occur which may damage the vehicle's electrical system.

Note: LED bulbs can be replaced only by a Land Rover Dealer/Authorised Repairer.

Wheels and tyres

READ NEXT:

 Wheels and tyres

 Smart key system transmitters

1. Steering column backup transmitter. 2. Front cockpit transmitters. 3. Front exterior door handle transmitters. 4. Roof keyless receiver. 5. Floor console front transmitter. 6. Rear exterior

 Tyre pressure monitoring system

SEE MORE:

  Rolling code device equipment programming

Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage door opener receiver (motor head unit) in the garage, locate the learn or smart button/switch. - T

  To erase all programming

For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off). 2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 second

© 2011-2026 Copyright www.rrevoque.org - 0.0034