Range Rover Evoque: Daytime Running Lamps (DRL)

Daytime Running Lamps (DRL)

Principles of Operation

For a detailed description of the Daytime Running Lamps (DRL) and operation, refer to the relevant Description and Operation section.

REFER to: Daytime Running Lamps (DRL) (417-04 Daytime Running Lamps (DRL), Description and Operation).

Inspection and Verification

1. Verify the customer concern.

2. Visually inspect for obvious signs of mechanical or electrical damage.

Visual Inspection

Range Rover Evoque. Daytime Running Lamps (DRL)

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step

4. If the cause is not visually evident, verify the symptom and refer to the Symptom Chart.

Symptom chart

Range Rover Evoque. Daytime Running Lamps (DRL)

DTC Index

For a list of Diagnostic Trouble Codes (DTCs) that could be logged on this vehicle, please refer to Section 100-00.

REFER to: Diagnostic Trouble Code (DTC) Index - DTC: Central Junction Box (CJB) (100-00 General Information, Description and Operation).

Daytime Running Lamps (DRL) - Overview

OVERVIEW

The DRL (daytime running lamps) and side lamps are incorporated into the headlamp assemblies.

Refer to: Exterior Lighting (417-01 Exterior Lighting, Description and Operation).

On vehicles with halogen headlamps, the DRL use the same LED (light emitting diode)s as the side lamps, but are illuminated at a higher intensity for DRL operation than for side lamp operation.

On vehicles with xenon headlamps, the 'signature' side lamp LEDs are used for the DRL function, but are illuminated at a higher intensity for DRL operation than for side lamp operation.

On Japan market vehicles, the DRL function is inoperative.

Functionality - ROW

DRL will be switched on when the following conditions are met:

The DRL will remain off if:

The DRL are illuminated at a higher intensity than the side lamp operation.

Depending on market, DRL will be dimmed to the intensity of the side lamp or switched off when the turn signal indicator on that side is active. For example, if the left turn signal indicator is active, the left DRL will be dimmed or switched off until the turn signal indicator becomes inactive. The opposite headlamp DRL will remain on at full intensity.

If the hazard warning lamps become active, the DRL are dimmed to the intensity of the side lamps on both headlamps until the hazard warning lamps are deactivated.

DRL will be switched off when the following conditions occur:

The DRL will not be switched off when the headlamp flash function is operated.

Functionality - NAS

DRL will be switched on when the following conditions are met:

The DRL will remain off if:

The DRL are illuminated at a higher intensity than the side lamp operation.

The DRL will be switched off when the turn signal indicator on that side is active. For example, if the left turn signal indicator is active, the left DRL will be switched off until the turn signal indicator becomes inactive. The opposite headlamp DRL will remain on at full intensity.

If the hazard warning lamps become active, the DRL are switched off until the hazard warning lamps are deactivated.

DRL will be switched off when the following conditions occur:

The DRL will not be switched off when the headlamp flash function is operated.

READ NEXT:

 Electrical Distribution & Electronic Feature Group

 Module Communications Network

 Central Junction Box (CJB)

Removal CAUTIONS: If a new component is to be installed, the Land Rover approved diagnostic equipment must be connected prior to removal, the data must then be downloaded from it and the keys (remote

SEE MORE:

 Replacing remote control batteries

Replacing remote control batteries With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a rep

 Wiper blade replacement

Fit only replacement wiper blades that are identical to the original specification. Before changing a wiper blade, the wiper arms must be set in the ‘service’ position as follows; Note: The Smart Key must remain in the vehicle while wiper blades are replaced. 1. Ensure that the ignition is

© 2011-2026 Copyright www.rrevoque.org