Range Rover Evoque: Deactivating the alarm when triggered
If the alarm has been triggered, it can be
deactivated by any one of the following
methods:
- Pressing the unlock button on the Smart
Key.
- Opening a door using keyless entry.
- Positioning a valid Smart Key underneath
the steering column and pressing the
START/STOP button. See previous
graphic.
READ NEXT:
Any person fitted with an
implanted
medical device should ensure that the
device is kept at a distance of at least
22 cm (8.7 inches) away from any
transmitter mounted in the vehicle.
This is
During vehicle recovery, a
Smart Key
must remain inside the vehicle, so that
the steering column remains unlocked.
See 216, RECOVERY.
Your vehicle is fitted with an electronic steering
column
If Valet mode is active when you enter the
vehicle, touch the Valet button to view the
Valet mode screen.
Enter your four digit PIN and touch the OK
button.
Valet mode is deactivated is displayed
SEE MORE:
Removal
1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
2. Refer to: B-Pillar Upper Trim Panel - 3-Door (501-05 Interior Trim and
Ornamentation, Removal and Installation).
3. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and
Ornament
Component Location
COMPONENT LOCATION - SHEET 1 OF 2
Central Junction Box (CJB)
Integrated Control Panel (ICP)
Rain/Light sensor (if fitted)
Right tailgate actuator (upper)
Rear wiper motor
Left tailgate actuator (upper)
Rear Junction Box (RJB)
Wiper control switch
Instrument Cluster (IC)
© 2011-2026 Copyright www.rrevoque.org
