Range Rover Evoque: Drive selector fails to elevate
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Drive selector fails to elevate
If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal.
If the selector still fails to elevate, even if there is no obstruction, a fault in the system is indicated. The selector can still be used in the lowered position. Ensure that P is selected before engine switch off. Have the fault rectified at the earliest opportunity.
READ NEXT:
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
Manual transmission
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo
Gear shift indicator
The gear shift indicator
illuminates
briefly at the recommended gear
change point (upshift).
The shift indicator will not illuminate while
Cruise control is active and is not being
overridden
SEE MORE:
Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be exercised when handling these
components.
NOTES:
Removal steps in this procedure may contain installa
Blower Motor RHD AWD/RHD FWD, RHD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. NOTE: The recirculation blend door must be closed
© 2011-2026 Copyright www.rrevoque.org
